Anyone else using OneKey? 2 years ago I spent like $10,000 upgrading our tools (old Milwaukee M28 system stuff) to the M18 system, but with OneKey….and it seems like it just stinks. Anyone else use it with good results? I can’t see where the tools are half the time. Batteries are dying, or it will show that it’s at the place I know it was at 5 days ago…but then I’m holding the tool in my hand.
Have you had good luck with it?
I have the milwaukee fuel cut off tool #2522-20 12v 3/8 or 7/16 and the M12 red lithyium XC4.0 batteries are falling off my tool ie, the clips that snap and hook onto the tool are breaking every time. That means I have to tape the handle and the battery so the batterie stays on the tool, everytime I have to charge the battery the process starts all over and the tape that works is expensive.
Can I take the batteries back and get new ones from home depot? Other than that Milwaukee has been extremely reliable
Duran the handyman Dallas
